Can someone please screengrab their settings for listening to the crossband repeater on the ISS at 437.8MHz?
I have the satellite tracking and doppler working ok but not having much success listening to the voices with either NFM Demod or WDSP Receiver.
Works pretty good on SDR Console
ISS Repeater settings
-
rxdftgyvhbujnik
- Posts: 2
- Joined: Sat Nov 15, 2025 1:55 am
Re: ISS Repeater settings
Haven't done it for a while, but if you post a screenshot I might be able to help.
-
rxdftgyvhbujnik
- Posts: 2
- Joined: Sat Nov 15, 2025 1:55 am
Re: ISS Repeater settings
Attached
- Attachments
-
- 2025-11-16 10_13_21-SDRangel.png (77.11 KiB) Viewed 8278 times
-
- 2025-11-16 10_11_57-SDRangel.png (37.93 KiB) Viewed 8278 times
Re: ISS Repeater settings
Would be useful to see the spectrum as well, to see what kind of signal you are receiving.
If you're not hearing anything, I'd guess the Sq(uelch) setting might be too high at -30. See that very low to begin with so you can hear the noise.
I think you might want to set CS (channel spacing) to 25 kHz rather than 12.5, so you get +- 5kHz deviation.
As you're using a RTL SDR, you might want to tune with a 10kHz offset, so you aren't receiving around the DC spike. E.g set the device frequency 10kHz lower, then set the FM Demod frequency offset to 10kHz.
If you're not hearing anything, I'd guess the Sq(uelch) setting might be too high at -30. See that very low to begin with so you can hear the noise.
I think you might want to set CS (channel spacing) to 25 kHz rather than 12.5, so you get +- 5kHz deviation.
As you're using a RTL SDR, you might want to tune with a 10kHz offset, so you aren't receiving around the DC spike. E.g set the device frequency 10kHz lower, then set the FM Demod frequency offset to 10kHz.
